Set the mapping for all the operands. In other words, OpdsMapping should hold at least getNumOperands ValueMapping.

Indicate that the specified operation does not work with the specified type and indicate what to do about it. Note that VT may refer to either the typ

Convenience method to set an operation to Promote and specify the type in a single call.

Sets the ordering constraint of this load instruction. May not be Release or AcquireRelease.

Sets the ordering constraint of this store instruction. May not be Acquire or AcquireRelease.

Sets the ordering constraint of this fence instruction. May only be Acquire, Release, AcquireRelease, or SequentiallyConsistent.

Sets the ordering constraint of this rmw instruction.

Initialize the original name hash in this summary.

setPHIJoin - Mark Reg as a phi join register.

Sets the list of known uses of pointer parameters.

Used by SymbolTableListTraits.

Set the profile to be partial. It means the profile is for common/shared code. The common profile is usually merged from profiles collected from runni

When EXPENSIVE_CHECKS is defined, "erased" index list entries will actually be moved to a "graveyard" list, and have their pointers poisoned, so that

Reset the MI position corresponding to the register pressure. This allows schedulers to move instructions above the RegPressureTracker's CurrPos. Sinc

Set the predicate for this instruction to the specified value.

Set the target's preferred function alignment. This should be set if there is a performance benefit to higher-than-minimum alignment

Set the target's preferred loop alignment. Default alignment is one, it means the target does not care about loop alignment. The target may also overr

Use of this should generally be avoided; instead, replaceVariableLocationOp and addVariableLocationOps should be used where possible to avoid creating

setRegAllocationHint - Specify a register allocation hint for the specified virtual register. This is typically used by target, and in case of an earl

Sets value of register mask operand referencing Mask. The operand does not take ownership of the memory referenced by Mask, it must remain valid for

These methods retrieve and set ifunc resolver function.

/ Assigns the SUnit to which this edge points.

The SizeAndActionsVec is a representation mapping between all natural numbers and an Action. The natural number represents the bit size of the InstrAs

If an operation on a given vector type (say <M x iN>) isn't explicitly specified, we proceed in 2 stages. First we legalize the underlying scalar (so

Specify the target scheduling preference.

Indicates the Section this function belongs to.

Set the section that this DIEUnit will be emitted into. This function is used by some clients to set the section. Not all clients that emit DWARF use

Sets the section ID for this basic block.

Specify the preferred (target independent) register allocation hint for the specified virtual register.

Restrict to a single domain available.

TODO: move setSize() and Size to DIEValueList.

TODO: move setSize() and Size to DIEValueList.

Don't read profile without context if the flag is set. This is only meaningful for ExtBinary format.

FIXME: Remove this function once transition to Align is over. Use the version that takes MaybeAlign instead of this one.

Set the module's original source file name.

This is an architecture-specific helper function of reassociateOps. Set special operand attributes for new instructions after reassociation.

\see StackID

If set to a physical register, this specifies the register that llvm.savestack/llvm.restorestack should save and restore.

Set the size of the stack.

Set the stage of a newly created instruction.