String implements Stringer interface.

Reset resets decoder, preparing it for the next run.

Read returns amount of currently read bytes. TODO: remove

Encode encodes data from reader and splits it into chunks to be futher converted to QR code frames.

Close closes underlying WebSocket connection.

State returns the current state of Session.

Decode takes a single chunk of data and decodes it. Chunk expected to be validated (see Validate) before.

IsCompleted reports whether the read was completed successfully or not.

Data returns decoded data.

NewEncoder creates and inits a new encoder for the given chunk length.

InProgress returns true if testing is in progress.

Decode takes a single chunk of data and decodes it.

NewDecoder creates and inits a new decoder.

SetState explicitly sets the session state to state.

DefaultSessionConfig creates config with default values.

Progress returns reading progress in percentage.

Render implements the vecty.Component interface.

AddResult adds a new result and refreshes the table.

Asset loads and returns the asset for the given name. It returns an error if the asset could not be found or could not be loaded.

Config returns current configuration.

CurrentSetup returns the test setup of the currently executing round.

Encode encodes data into the image with QR code.

NewDecoder creats new txqr decoder.

NewSession inits new test session. Default State is StateNew.

ProcessResult handles request to process new incoming result.